When setting the brightness to make sure the brightness is too bright at its brightest mode to enable the images to be bright. You will find a where to adjust the brightness whether up or down the bar for brighter or lower brightness. This could be achieved by going into the display and brightness in your device. Then peel off the top paper to make it sticky to place your phone on it.Īfter placing your phone in place in the shoebox, go to Settings on your device and adjust the brightness of your device. Place them lengthwise along with the piece that is standing of your phone stand and stick them together. Take a scissor and cut two strips of the double-sided tape about 15 cm long in length. While placing the boards up down to form a T, the longest edge of the standing board running in the middle of the bottom board. Arrange your foam to form a T shape upside down and stick it with hot glue. With foam that is cut 6.5-inch x 4 in, will make a stand that is large enough to hold the Smartphone or you may have to measure the device you are going to use and make a stand for it according to your measurement.Īfter measuring the foam well and getting them in the right size, it is time to stick them together for use. Be careful not to injure your hand while cutting it down especially if you are using the utility knife. Gets foam that is thick from any store and cut it into pieces that will fit your phone using a knife or any sharp object. Sticks the construction papers with multipurpose glue and hold them together until they are stuck well at the edges inside the box. Make sure the inside of the box is well fit with the constriction paper. Having measured the length and the width of the sides inside the shoebox, cut the construction paper using scissors to meet the measurement and fit the sides well. Follow the line well and trace it with the hot glue to make sure it is fit for your placement. To hold the lens and the box together, you may use the hot glue gum or place dust tape at the edges of the lens together. Make sure the side that you see through in the lens is placed inside partially. Place your magnifying lens in a place where you have removed the box you traced. If you are kids make sure you have a grown up with you while making the projector. Be careful while cutting the traced circle of the box not to damage the table with your knife or not to injure your hand. Make sure you follow the traced line well until it is completely removed from the box. After tracing the magnifying lens by making a circle on it, use a sharp object to cut through the traced circle well and precise. Then place the magnifying lens on the other side at the top and trace using a pensile. With your magnifying lens, on the one hand, place the box vertically on the table with one small side we placed on the table. Position the magnifying lens well in the shoebox.In case the box is loose on the sides, stick it together using glue and hold it until they are stuck together really well. Make sure that the box is fitting match to the device you are going to use as the tablet, smartphones and others. Get a shoebox in your home that you are not using any size that is sturdy. Make sure your shoebox is well glued on the sides.If you are getting a lens from your home make sure it is one that you will not need to do something else with it as it will not be good to remove from the movie projector and in another object it may not work well again on the other object. Place the lens at the edge of the table and cut off the handle using a hacksaw.Īlso if you have other available unused lenses at home, you may prefer to use them instead of too much work. You should get a magnifying glass from the office if you have one or buy at any store that has them.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |